What all would i have to upgrade internally in my G&G m4?
+2
superchrisguy
tzvooma
6 posters
11.1 lipo for G&G
superchrisguy- Posts : 786
Join date : 2010-01-20
Age : 32
Location : Warner Robins
- Post n°2
Re: 11.1 lipo for G&G
I would get a better motor (matrix magnum, matrix turbo), a mosfet (you don't want to fry your contacts), a new piston (one with full metal or steel teeth), and maybe some better gears.
flipa- Posts : 973
Join date : 2010-06-20
Location : Over the rainbow
- Post n°3
Re: 11.1 lipo for G&G
Just get a mosfet.
-a|ex- Posts : 757
Join date : 2010-09-10
Age : 59
Location : Tyrone, GA
- Post n°4
Re: 11.1 lipo for G&G
i recommend replacing the wiring with low res wires or thicker gauge (16 awg). a mosfet will be needed to relay power to the motor instead of passing through your trigger contacts (prevents premature wear on trigger contacts). it is always a good idea to adjust AOE whenever you upgrade performance. if you haven't done so, re-shim and re-lube the mechbox.
there are different types of mosfets. i prefer non-AB with either a fuse or resettable fuse. LiPo's can get damaged if drained or over charged. if they plump up, they might burst into flames. a voltage monitor is recommended or just change them out when you think they might start to drain. they also require a balancer charger and a safe location that won't burn the house down if a battery has a bad cell (recommend using a LiPo charging bag).
there are different types of mosfets. i prefer non-AB with either a fuse or resettable fuse. LiPo's can get damaged if drained or over charged. if they plump up, they might burst into flames. a voltage monitor is recommended or just change them out when you think they might start to drain. they also require a balancer charger and a safe location that won't burn the house down if a battery has a bad cell (recommend using a LiPo charging bag).
sniper2525- Posts : 1036
Join date : 2009-02-21
Age : 32
- Post n°5
Re: 11.1 lipo for G&G
flipa wrote:Just get a mosfet.
wrong need more than mosfet my friend
RIP- Posts : 179
Join date : 2010-07-14
Age : 32
Location : Fayetteville, GA
- Post n°6
Re: 11.1 lipo for G&G
what more would you need to put in it?
this seems right to mesuperchrisguy wrote:I would get a better motor (matrix magnum, matrix turbo), a mosfet (you don't want to fry your contacts), a new piston (one with full metal or steel teeth), and maybe some better gears.
|
|